Bought this motor back in May. I’ve used ethanol free since then and motor has always run great for me. My motor went for about a month being unused and it would crank but then putter out. So I took the carbs out and cleaned them, one of the pins did seem to have a clog. Put the carbs back in and the motor cranked right up but was sneezing at idle and especially after I would rev the throttle and the rpms came back down. It never died at idle but it would sneeze (smoke shoot out of the prop area).
So I took the carbs apart again and unscrewed the low speed needles in both carbs out one complete turn, the first time I put it back together I had them screwed in all the way. Same thing is still happening. Starts up great but is sneezing, never did this before I messed with the carbs.
I haven’t put it under a load yet, only thing I have done is run it on muffs.
Bulb is pumping gas into carbs but doesn’t seem to be getting super firm.
Also I didn’t replace any of the gaskets when I took apart the carbs.
This is my first time messing with outboard carbs so any help would be appreciated. Thoughts?