I am working on the old boat and am in need of a grab bar for my center console. Any suggestions on who could do this for me? Also, any idea on approximate cost? This is the console in question:
By the way I have a light tower available for sale or trade if anyone is interested. It came off the boat above.
I am also interested in trading the trailer for a single axle 
I could help you out, but I’m up in Columbia, and I would need your console to get the right fit. I’ve heard of several guys near Charlesto that do good work. Mark Googer comes to mind. There’s also Clover Enterprises in Summerville.
Bob Van Gundy
Marine Designs,Inc.
Custom Aluminum Fabrication
803-727-4069
How wide? I have a couple of brand new stainless steel console grab rails I’m in need of getting rid of. One is fixed and the other will fold down.
Same here…Get a width and if Wstrickland doesn’t have it im sure I have one that will work for ya. They are just sitting in the garage and need gone
Okay, let me try to describe the dimensions… Look at the first picture for this.
28" wide between lowest brackets (lowest dark circle towards the front of the console.
25.25" wide between the brackets just above those (this is harder to see, but it’s just below the windshield directly above lowest brackets)
26.25" wide between brackets on back side (next to steering wheel)
As you can see, it tapers in. Hope this helps!
Go to Lowe’s and ck out the plumbing section they have a great selection of stainless grab bars, Have had some on my CC for years!
boatpoor, good suggestion. But, I was wanting one that wraps around the windshield. Sorry, should’ve been more specific. Though, a handle would be useful elsewhere.