Had i pilot 80lb, 60" installed at Chas. Marine I think last March,used it probably 4 times.I was getting boat ready for tomorrow and noticed puck loose when I shook trolling motor shaft.Not bad but never noticed before,will look at good light tomorrow,any tips or experience on tightening up? I know they will fix it but would sure like to use in the late morning at reefs if possible. thanks for any info. Its a Bulls Bay 2200
The GPS puck or the quick release mount bracket? Either way it should easily be tightened up with the screws used to install it one would think. If it has wallered out then you have a whole new set of issues… maybe take off the trolling motor and get a closer look if it is the bracket, maybe even post some pics.
Fishing Nerd
“skilled labor isn’t cheap, cheap labor isn’t skilled”
if the puck is moving, we need to see it ASAP
it should be through bolted with lock nuts, so it shouldnt be able to loosen up, unless there is a structural issue with the deck.
www.teamcharlestonmarine.com
www.bombislandboats.com
IF I RESPOND IN ALL CAPS, ITS NOT ON PURPOSE, AND I AM NOT YELLING
Chris V- I took trolling motor off and tighten the 4 phillips head bolts in the puck,will pull motor off again today and check again and call your shop if they have loosened up again, Thanks for responding
You can’t catch fish on a dry line
your install required toggle bolts, so it is possible they pulled into the deck a bit, or even loosened from vibration.
just tightening them should be fine,
www.teamcharlestonmarine.com
www.bombislandboats.com
IF I RESPOND IN ALL CAPS, ITS NOT ON PURPOSE, AND I AM NOT YELLING